Maintenance - Husqvarna RIGG 900 FE Operator's Manual

To stop the product
1. Push the OFF button on the remote control for 3
seconds. The LED flashes red before the remote
control goes off.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
WARNING:
from the power supply before maintenance.
WARNING:
equipment when you do maintenance. Refer
Personal protective equipment on page 6 .
to
WARNING:
is on flat ground when you do maintenance.
General product maintenance
Make sure that bolts, nuts, and screws are tight. Do this also 12 h
after servicing and repairs.
Do a check of the electrical components, the cables, and all
connections for wear and damages.
Do a check of the electric motor for wear and damages.
Clean the inner parts of the electrical enclosure.
Do a check of the RCD.
Do maintenance on the remote control. Refer to the manufactur-
er's manual for the remote control.
14

Maintenance

Before you do
Disconnect the product
Use personal protective
Make sure that the product
2. Set the ON/OFF switch (A) in the OFF position. The
green indicator for control voltage (B) goes off.
B
3. Disconnect the product from the power supply.
For all servicing and repair work on the product, special
training is necessary. Always use personal protective
equipment We guarantee the availability of professional
repairs and servicing. If your dealer is not a service
agent, speak to them for information about the nearest
service agent.
For more detailed information, refer to
www.husqvarnaconstruction.com.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Each 50 h
*
A
Daily Yearly
*
*
*
*
*
* *
2150 - 002 - 08.02.2024