Husqvarna 2-20DT Global Operator's Manual page 24

2. Remove the nuts of the blastwheel covers.
3. Install M10 bolts on the welded nuts. Turn the M10
bolts to release the blastwheel covers from the blast
housings.
4. Remove the blastwheel covers.
24
5. Put an applicable tool in the blastwheels to prevent
rotation. Remove the bolts.
6. Remove the blastwheels.
7. Install the blastwheels in opposite sequence.
CAUTION:
when you install the new blastwheels.
To do a check of the chain tension of
the drive system
WARNING:
without the chain cover installed.
1. Stop the product. Refer to
page 21 .
Always use a new bolt
Do not operate the product
To stop the product on
2037 - 001 - 07.02.2023