Table of Contents
Advertisement
Problem
When connected by the
USB Cable, this unit is not
detected by the PC.
When the USB Cable is
disconnected, an error
message will appear on
the PC.
Problem
If the SD card is inserted in
this unit, it is not
recognized.
∫ If AVCHD scenes do not change smoothly when played back on
another device
The images may be still for several seconds at the joins between the scenes if the following
operations are performed when multiple scenes have been continuously played back using another
device.
≥ Just how smoothly the scenes will be played back depends on the playback device. Depending
on the device used, the images may stop moving and become still for a moment even when none
of the following conditions are applicable.
≥ A continuous recording of motion picture data that exceeds 4 GB may momentarily stop at every
4 GB of data when played back with another device.
≥ The recording format [PS] was switched to another recording format when a scene was
recorded
≥ When the scenes were recorded on different dates
≥ When scenes lasting under 3 seconds have been recorded
≥ When PRE-REC was used for recording
≥ When the Interval Recording is used
≥ When deleting scenes
≥ When scenes recorded more than 99 scenes on the same date
With a PC
≥ After re-inserting the SD card into the unit, reconnect the USB
Cable.
≥ Select another USB terminal on the PC.
≥ Check the operating environment.
≥ Connect the USB Cable again after restarting the PC and
turning on this unit again.
≥ To disconnect the USB Cable safely, double-click the
icon in the task tray and follow the instructions on the screen.
≥ If the SD card is formatted on a PC, it may not be recognized
by this unit. Use this unit to format SD cards.
Principal reasons for not playing back smoothly
Check points
Others
Check points
- 151 -
(l
99)
(l
36)
Advertisement
Table of Contents
