Tensioning The Running Belt; Treadmill Lubrication - True CS400 Owner's Manual

CHAPTER 5: CARE & MAINTENANCE
RUNNING BELT ALIGNMENT (continued):

TENSIONING THE RUNNING BELT:

If there is a slipping or jerking sensation when running on the treadmill, the running belt may require tightening. In most
cases the belt has stretched from use. Tensioning the belt takes a few simple adjustments. If you are unsure about this
procedure, call the TRUE Service Department.
• Locate the belt adjustment bolts in the rear end caps of
the treadmill.
•
Using the appropriate size Allen wrench or socket turn
BOTH adjustment bolts clockwise ¼ turn.
• Turn the treadmill on and start the belt and check if the
slipping continues. Repeat the above steps if additional
adjustment is necessary.

TREADMILL LUBRICATION:

For commercial use over 20 hours per week, TRUE recommends lubricating every three months.
If the running belt is too far to the left side:
•
Locate the belt adjustment bolts in the rear end caps of the
treadmill. (To determine left and right, stand at the rear of the
treadmill and face the display).
•
Using the appropriate size Allen wrench or socket turn the
LEFT adjustment bolt clockwise ¼ turn.
• Turn the treadmill on and start the belt at 3mph keeping off
the unit.
•
Allow 2 minutes for the belt to adjust itself.
•
Repeat the above steps if additional adjustment is necessary.
•
•
•
•
*Please contact your dealer or visit www.truefitness.com to obtain the
proper lubricants.
Truefitness.com / 800.426.6570 / 636.272.7100
Loosen the belt adjustment bolts in the rear end caps.
Lift the belt and apply the lubricant to the center of the deck.
Center and re-tension the belt using the directions above.
Walk on the treadmill at 2MPH for about 60 seconds to
spread the lubricant evenly through the belt and deck.
123