Table of Contents
Advertisement
ENGLISH
45
45
4219-465-05501 MANUAL GAG. BESANA EN KOR.indd 45
Heating up the machine
During the initial heat-up process, fresh water flows through the internal circuit to
heat up the machine. This takes a few seconds.
1
Place a bowl under the hot water/steam wand or classic milk frother and the
coffee spout. Make sure the control dial points to the coffee bean icon.
2
Press the on/off button.
3
When the warning light flashes quickly, turn the control dial to the hot water
icon and wait a few seconds.
-
The warning light goes out and some water comes out of the hot water/
steam wand or classic milk frother.
4
After a few seconds, when hot water stops coming out of the hot water/steam
wand and the warning light flashes slowly, turn the control dial back to the
coffee bean icon.
-
The machine is heating up and the on/off button flashes slowly.
-
When the machine has heated up, it performs an automatic rinsing cycle to
clean the internal circuit with fresh water. Water flows from the coffee spout.
-
When the on/off button lights up continuously, the machine is ready for the
manual rinsing cycle.
Note: You can stop the automatic rinsing cycle by pressing the espresso button or
the regular coffee button.
Note: The automatic rinsing cycle also takes place 15 minutes after the appliance
switches to standby mode or switches off.
12/02/2021 11:18:42
Advertisement
Table of Contents
