Configuring The Relay Multiplexer Modules; Warnings And Cautions - HP E1343A User Manual

Configuring the Relay Multiplexer Modules

Warnings and Cautions

WARNING
Caution
Chapter 2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This chapter shows how to connect external wiring to the 16-Channel Relay
Multiplexer Modules, and how to configure them:
•
Warnings and Cautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 19
•
Connecting Field Wiring. . . . . . . . . . . . . . . . . . . . . . . . . . . . page 20
•
Wiring a Terminal Module . . . . . . . . . . . . . . . . . . . . . . . . . . page 21
•
Connecting the Analog Bus . . . . . . . . . . . . . . . . . . . . . . . . . page 22
•
Setting the Card ID . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 23
•
Setting the Logical Address Switch . . . . . . . . . . . . . . . . . . . page 23
•
Using the Multiplexer Module with an HP Mainframe or Command
Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 24
•
Selecting the Interrupt Priority . . . . . . . . . . . . . . . . . . . . . . . page 26
•
5 Volt Excitation for Strain Gages . . . . . . . . . . . . . . . . . . . . page 27
•
Adding Signal Conditioning Components/Current Shunts . . page 27
•
Connecting User Inputs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 29
SHOCK HAZARD.
Only service-trained personnel who are aware of
the hazards involved should install, remove, or configure the
modules. Before installing any module, disconnect AC power from the
mainframe and from user wiring.
To prevent electrical shock, all wires to the channel connections must
be insulated to at least 120 Vrms (170 V peak).
MAXIMUM VOLTAGE/CURRENT.
applied between High (H), Low (L), and Guard (G) terminals is 170 V
dc or 120 V rms (170 V peak) for the E1345A/47A or 250 V dc or AC
RMS (354 V peak) for the E1343A/44A. Maximum current is 50mA
(non-conductive) per channel.
STATIC ELECTRICITY.
component failure. To prevent damage to the electrical components in
the multiplexer module, observe anti-static techniques whenever
removing a module from the mainframe or whenever working on a
module.
Configuring the Relay Multiplexer Modules
Maximum voltage that may be
Static electricity is a major cause of
Chapter 2
19