Operation[:Event] - HP E1343A User Manual

:OPERation[:EVENt]?

Comments
Example
64 Relay Multiplexer Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
STATus:OPERation[:EVENt]?
Register (only bit 8 is used by the multiplexer modules).
•
Setting Bit 8 of the Operation Status Register: Bit 8 (Scan Complete) is set
to 1 after a scanning cycle completes. Bit 8 returns to 0 after sending the
STATus:OPERation[:EVENt]?
•
Returned Data after sending the
Command: The command returns
Register is set to 1. The command returns
Register is set to 0.
•
Related Commands:
Reading the Operation Status Register after a Scanning Cycles
STAT:OPER?
read and print the register value
returns the bit value of the Operation Status
command.
STATus:OPERation[:EVENt]?
+256 if bit 8 of the Operation Status
+0 if bit 8 of the Operation Status
[ROUTe:]SCAN
Returns the bit values of the Standard
Operation Status Register.
+256 shows bit 8 is set to 1;
+0 shows bit 8 is set to 0.