Related Manuals for Smithco Spray Star 3187
Summary of Contents for Smithco Spray Star 3187
- Page 1 Operator’s Spray Star 3187/3188 SharpShooter-Rate Sync w/ Raven 440 with 18’ and 20’ Booms July 2016 Product Support: Hwy SS & Poplar Ave; Cameron WI 54822 1-800-891-9435 productsupport@smithco.com...
-
Page 2: Table Of Contents
CONTENTS Introduction..............1-11 Introduction ..............1 Symbols ..............2-3 Safety ................4 Safety Decal location ..........5 General Safe Practices ..........6 Safe Spraying Practices ..........7 Specifications .............. 8 Optional Spray Equipment .......... 8 Set Up ................. 9 Controls & Instruments .........10-11 Operation .............. -
Page 3: Introduction
All Smithco Smithco Smithco Smithco machines have a Serial Number and Model Number. Both numbers are needed when ordering Smithco parts. The serial number plate on the Spray Star 3180 is located on top of the frame, between the hydro pump and spray tank. -
Page 4: Symbols
Temperature Gasoline Diesel Glow Plug - On Glow Plug - Off Glow Plug Hour Meter Hour Meter Fuse Hand Throttle Choke - Closed Choke - Open Park Brake Hydraulic Oil Park Brake Release Level PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 5 Up/Down Arrow Down/Lower Up/Raise Manual No Smoking Moving Parts Operation Step Hot Surface Pinch Point Hydraulic Fluid Lift Arm Tractor Penetration Engage Disengage Ground Speed Fast Slow Forward High Warning Danger Reverse Neutral Caution PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 6: Safety
It may also be used to alert against unsafe practices. IMPORTANT: Blue. Indicates procedures which should be followed to avoid damage to the machine. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 7: Safety Decal Location
15-463 Decal Spray Pump 25-375 Decal, 94 dBA 25-277 Decal, Battery Warning 25-286 Decal, Pinch Point 25-298 Decal, Warning Hot 25-321 Decal, Diesel Fuel Only 20-545 Decal, Dash Panel 30-157 Decal, Control Panel PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 8 These machines are intended for professional maintenance on golf courses, sports turf, and any other area maintained turf and related trails, paths and lots. No guaranty as to the suitability for any task is expressed or implied. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 9: Safe Spraying Practices
19. TRANSPORT - Machine must be stopped to raise or lower booms. Because of cam system, if booms are raised in transit they can fall forward or backward when coming to a stop or while traveling on uneven terrain. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 10: Specifications
20' HD Super Boom 30-004 Foam Marker 30-006 Fresh Water Tank 15-835 Tank Rinse System 30-007 Chemical Cleanload Safe Fill 15-850 Sunshade Canopy 31-006 All Weather Top 17-590 Lazer-Beam Auto Boom for HD Booms PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 11: Setup
SETUP The Spray Star 3180 arrives from Smithco setup and ready for service. Depending on freight conditions battery installed. The spray system is normally shipped attached to the 3180 Prime Mover. If a spray system is to be fitted to a Prime Mover by a dealer or factory, assemble and attach the components in accordance with the parts drawings in the Spray Star 3180 Parts/Service Manual. - Page 12 Tighten the lock nut and pump handle until hard. Run machine at half-throttle minimum, prior to operating trac- tion pedal. This will ensure proper brake release. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 13: Controls & Instruments
Q. Park Brake Toggle Switch - This toggle switch will engage park brake. Lift toggle cover and move switch forward. DO NOT ENGAGE WHILE IN MO- TION. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 14 2. Obtain desired speed with foot pedal. 3. Step on foot switch to lock speed. 4. Push foot switch again to disengage. To avoid abrupt stop, place foot on traction pedal before disengaging speed control. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 15: Operation
3. Remove the ignition key and engage the park brake. Never leave the vehicle unattended with the engine running. Always bring the vehicle to a complete stop, engage park brake, turn key off and remove key. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 16 4. Connect other end of cable (D) to engine block on unit being started (NOT to negative (-) terminal of battery) To prevent damage to other electrical components on unit being started, make certain that engine is at idle speed before disconnecting jumper cables. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 17 Envizio Pro II comes with a Quick Reference Guide and an Installation & Operation Manual. Please read these manuals before operation. Manuals can be downloaded off the internet at www.ravenprecision.com and off the www.smithco.com website under Parts and Technical Information. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 18 SHARPSHOOTER WITH RATE SYNC FEATURES Auto/Manual POWER Button To Begin a Job & Create a Spray Zone Turn Sharpshooter w/RateSync On Press Auto/Manual button to Auto PSI is preset. Use arrow buttons to increase/decrease PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 19: Raven 440 Console Features
VALVE CAL Control Valve Response Time VOLUME/TANK Volume Remaining in Carrier Tank RATE 1 CAL Target Application Rate TIME 24 hour clock (military time) RATE 2 CAL Target Application Rate SELF TEST Simulates Vehicle Speed PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 20: Console Programming
If the Distance display reads any other value, divide Speed Cal by the value observed in Distance, then multiply by 5280. This will give you the correct value to enter for Speed Cal. You must round off to the nearest 3 digit number (use 120 not 120.3). PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 21 Nozzle Charts Section, since it comes closest to providing the desired output. VERIFYING FLOW RATE LIMITS The flow rate of the sprayer must be within the range of 1 to 55 GPM (4 to 210 lit/min). PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 22: Initial Programming
If there is only one boom, enter "0" for width of BOOM 2. 7. Enter width in inches (cm) of BOOM 3 in the key labeled: If there is only one or two boom, enter “0” for width of BOOM 3. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 23 To “zero out” this total, at any time enter a “0” in this key. 5. To display DISTANCE (feet (meters) traveled) momentarily depress key labeled: To “zero out” this total, at any time, enter a “0” in this key. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 24 5 seconds, OLD CODE message will appear. 2. Enter 4 digit OLD CODE within 15 seconds. EXAMPLE: depress NEW CODE message will appear. Enter 4 digit code within 15 seconds. EXAMPLE: For 1285, depress PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 25 3 = 10% + Deadband 7 = 35% + Deadband Actual rate is displayed if unit does not reach deadband with in 10 seconds. “doFF” means RATE displays ac- tual rate at all times. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 26 11. Hold the MAN ADJ switch in DECR position for approximately 12 seconds. This assures motorized control valve is fully closed. Verify minimum pressure and RATE can be achieved. If not, consider bypass plumb- ing system in Appendix 3. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 27: Spray Operation
Located to the right of the control panel. Use lever on compressor to designate which boom is to be used to dispense foam. Use dial located on the foamer to adjust pressure for the amount of foam that will be dispensed. Switch on compressor also turns foamer on or off. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 28 This section is intended to offer practical guidelines for the distribution of liquid chemicals over an area of turf grass such as golf courses, park land, school grounds and lawns. SMITHCO makes no representation as to the suitability of any technique or product for any particular situation. This section is suitable for self-propelled spray vehicles or sprayers mounted onto vehicles.
-
Page 29: Turf Management
" (1.25 cm) inside diameter hose is adequate. Trees over 40 ft (12 m) high re- quire " (2 cm) inside diameter hose and a sprayer pump capable of delivering a volume of at least 20 gpm (75 lpm) and a pressure of at least 400 psi (28 bar). PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 30: Troubleshooting Nozzle Valves
O-ring 30-168-20P Valve Body 30-168-26P Flynut 30-168-25P Plunger 30-168-17P O-ring 30-168-19P Coil 30-168-21P Complete Nozzle Valve Assembly 30-168-05P The nozzle valve assembly (30-168-05P) screws into the nozzle bodies replacing the standard diaphragm check valve. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 31 The result is erratic pulsing, often described as “flicker- ing.” SharpShooter will operate normally at lower pres- sures until replacement parts can be acquired. High operating pressures and abrasive spray solutions will accelerate the wear of the plunger seal material. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 32: Collection Times
COLLECTION TIMES Speed/ MPH Feet/Min Fixed Distance Minutes Seconds Seconds 204 1.159090909 69.54545455 184.8 204 1.103896104 66.23376623 193.6 204 1.053719008 63.2231405 202.4 204 1.007905138 60.4743083 211.2 204 0.965909091 57.95454545 204 0.927272727 55.63636364 228.8 204 0.891608392 53.4965035 237.6 204 0.858585859 51.51515152 246.4 204 0.827922078 49.67532468 255.2... -
Page 34: Declaration Of Conformity
2000/14/EÜ mõistes Direktiivin 2000/14/EY mukainen ilmoitettu tarkastuslaitos Isossa-Britanniassa Organisme notifié concernant la directive 2000/14/CE Britische benannte Stelle für 2000/14/EG 2000/14/ Smithco West Inc. 2000/14/EK – egyesült királyságbeli bejelentett szervezet Organismo Notificato in GB per 2000/14/CE 2000/14/EK AK re istr t organiz cija 200 West Poplar Avene... - Page 35 The place and date of the declaration Místo a datum prohlášení Sted og dato for erkl æringen Plaats en Smithco West Inc. datum van de verklaring Deklaratsiooni väljastamise koht ja kuupäev Vakuutuksen paikka ja päivämäärä Lieu et date de la déclaration 200 West Poplar Avenue Ort und Datum der Erklärung...
-
Page 36: Quick Reference
QUICK REFERENCE REPLACEMENT PARTS REPLACEMENT FILTERS 72-146 Hydraulic Oil Filter Assembly 60-334 Replacement Element 30-042-05 Air Cleaner Cartridge 13-488 Key Switch 30-042-08 Fuel Filter Element 30-042-09 Engine Oil Filter 77-217 Exhaust Muffler Gasket REPLACEMENT BELTS 30-137 Spray Pump Belt 30-042-11 Fan Belt SEAL KITS 15-301... - Page 37 30 days from discovery of the condition. If you need help locating an Authorized Smithco Distributor, or if you have questions regarding your warranty rights or responsibilities, you may contact us at:...
- Page 38 This warranty does not apply to normal “wear and tear” items. Normal “Wear and Tear” includes, but is not lim- ited to, damage to seats due to wear or abrasion, worn painted surfaces, scratched decals or windows, etc. Smithco may require the return of failed parts or components in order to determine the validity of any warranty claim.
Need help?
Do you have a question about the Spray Star 3187 and is the answer not in the manual?
Questions and answers