Area Code Formatting; Contrast; Dialing Mode; Display Contrast - Philips VOIP3211 User Manual

Set dialing mode (Tone/Pulse)
Dialing mode applies only when you are making a telephone call. Your phone is by default set to tone dialing.
You can switch to pulse dialing if necessary.
1. In idle mode, press
2. Select ADVANCED SET and press OK.
3. Select DIAL MODE and press OK. The current setting is displayed.
4. Select TONE or PULSE and press OK to confirm.
Temporary tone dialing in pulse dial mode
If the dialing mode is set to pulse, you can long press
displayed on the screen. All the following digits will be dialed as tones until you hang up.

Flash duration

Your phone comes with 2 factory programmed flash durations. Check with your local service provider if you
are not sure which duration to use.
1. Press .
2. Select ADVANCED SET and press OK.
3. Select FLASH and press OK. The current duration is displayed.
4. Select FLASH 1 or FLASH 2.
5. Press OK to confirm.

Area code formatting

Enter the 3 digits local area code so that the caller ID can be formatted properly.
1. Press .
2. Select ADVANCED SET and press OK.
3. Select AREA CODE and press OK.
4. Enter the area code.
5. Press OK to confirm.
Set display contrast
1. In idle mode, press
2. Select PERSONAL SET and press OK.
3. Select CONTRAST and press OK. The current setting is displayed.
4. Press UP / DOWN
Other features
.
.
to adjust the contrast and press OK to confirm.
to set temporary tone dialing. d will be
US
33