Hyundai ELANTRA 2006 Owner's Manual page 143

H290F02O-GAT
1. CD Select Button
o Insert the CD with the label facing
upward.
o Insert the CD to start CD playback,
during radio operation or cassette
tape playing.
o When a disc is in the CD deck, if you
press the CD button the CD player
will begin playing even if the radio or
cassette player is being used.
o The CD player can be used when the
ignition switch is in either the "ON" or
"ACC" position.
2. FF/REW ( / )
If you want to fast forward or reverse
through the compact disc track, push
and hold in the FF ( ) or REW (
button.
When you release the button, the com-
pact disc player will resume playing.
3. TRACK UP/DOWN
o The desired track on the disc cur-
rently being played can be selected
using the track number.
o Press button once to skip for-
ward to the beginning of the next
track. Press button once to skip
back to the beginning of the track.
4. REPEAT
o To repeat the track you are currently
listening to, press the RPT button.
To cancel , press again.
o If you do not release RPT operation
when the track ends, it will automati-
cally be replayed.
This process will be continued until
you push the button again.
)
5. EQUALIZER Button
Press the EQ button to select the
CLASSIC, JAZZ, ROCK and DEFEAT
MODE for the desired tone quality.
Each press of the button changes the
display as follows;
CLASSIC → JAZZ → ROCK → DEFEAT
FEATURES OF YOUR HYUNDAI
6. CD EJECT Button
When the button is pressed with
a CD loaded, the CD will eject.
7. SCAN Button (If installed)
o Press the SCAN button to playback
the first 10 seconds of each track.
o Press the SCAN button again within
10 sec. for the desired track.
NOTE:
o To assure proper operation of the
unit, keep the vehicle interior tem-
perature within a normal range by
using the vehicle's air condition-
ing or heating system.
o When replacing the fuse, replace
it with a fuse having the correct
capacity.
o The preset station frequencies are
all erased when the car battery is
disconnected. Therefore, all data
will have to be set again if this
should occur.
o Do not add any oil to the rotating
parts. Keep magnets, screwdriv-
ers and other metallic objects away
from the tape mechanism and head.
1
129