Table of Contents
Advertisement
B970C02E-GAT
Automatic Operation
HXD118D
The FATC (Full Automatic Tempera-
ture Control) system automatically con-
trols heating and cooling by doing as
follows:
1. Push the "AUTO" button. The indica-
tor light will illuminate confirming that
the Face, Floor and/or Bi-Level
modes as well as the blower speed
and air conditioner will be controlled
automatically.
HXD118A
2. Push the "TEMP" button to set the
desired temperature.
The temperature will increase to the
maximum 32°C(90°F) by pushing on
the " " button. Each push of the
button will cause the temperature to
increase by 0.5°C(1°F).
The temperature will decrease to the
minimum 17°C(62°F) by pushing on
the " " button. Each push of the
button will cause the temperature to
decrease by 0.5°C(1°F).
FEATURES OF YOUR HYUNDAI
NOTE:
If the battery has been discharged or
disconnected, the temperature mode
will reset to Centigrade degrees.
This is a normal condition and you
can change the temperature mode
from Centigrade to Farenheit as fol-
lows;
Press the
button down 3 sec-
TEMP
onds or more with the
button
OUTSIDE
TEMP
held down. The display shows that
the unit of temperature is adjusted to
Centigrade or Fahrenheit.
(°C
°F or °F
°C)
→ → → → →
→ → → → →
Photo sensor
HXDFL281S
1
97
Advertisement
Chapters
Table of Contents
