Table of Contents
Advertisement
EXTENSION CORD SAFETY
WARNING: Keep the extension cord clear of the working area. Position the
cord so it will not get caught on the workpiece, tools or any other obstructions while
you are working with the power tool.
Make sure any extension cord used with this tool is in good condition. When using
an extension cord, be sure to use one of heavy enough gauge to carry the current
the tool will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating.
The table below shows the correct size to use according to cord length and nameplate
ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge
number the heavier the cord.
Be sure your extension cord is properly wired and in good condition. Always replace
a damaged extension cord or have it repaired by a qualified electrician before using
it. Protect your extension cord from sharp objects, excessive heat and damp or wet
areas.
Use a separate electrical circuit for your power tools. This circuit must not be less
than 14 gauge wire and should be protected with either a 15 AMP time delayed fuse
or circuit breaker. Before connecting the power tool to the power source, make sure
the switch is in the OFF position and the power source is the same as indicated on
the nameplate. Running at lower voltage will damage the motor.
MINIMUM GAUGE (AWG) OUTDOOR GRADE EXTENSION CORDS (120V USE ONLY)
Amperage rating
More than
Not more than 25' /7.5 m
0
6
10
12
To reduce the risk of disconnection of lawn mower from the extension cord during
operating: Make a knot as shown in Fig. 1;
Use one of the plug-receptacle retaining straps or connectors described in this
guide.
SAVE THESE INSTRUCTIONS FOR REFERENCE
7
6
18
10
18
12
16
16
14
15 Amp Lawn Mower
Total length
50' /15 m
100' /30 m
16
16
16
12
Owner's Manual
150'/45 m
16
14
14
12
14
12
Not Applicable
Advertisement
Table of Contents
