Disassembly Instructions - Mitsubishi Electric MSZ-A09NA Series Service Manual

9

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
9-1. MSZ-A09NA MSZ-A12NA MSZ-A15NA MSZ-A17NA MSY-A15NA MSY-A17NA
OPERATING PROCEDURE
1. Removing the panel
(1) Remove the horizontal vane.
(2) Remove the screw caps of the panel. Remove the
screws. (Photo 1)
(3) Hold the lower part of both ends on the panel and pull
it slightly toward you, and then remove the panel by
pushing it upward.
Photo 3
MSZ-A09/12/15/17NA -
1
MSY-A15/17NA -
1
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Photo 1
Horizontal vane
Screw of the
conduit cover
Terminal block
cover
Photo 2
Conduit cover
25
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
PHOTOS
Screws of the panel
MSZ-A09/12/15/17NA
MSY-A15/17NA
Terminal block
cover
Conduit cover
Screw of the
conduit cover
Conduit plate