Westfalia AMS 18 Instructions Manual page 17

 Ensure that the lighting is adequate.
 Do not exert pressure on to the tool. To do so would shorten
its service life.
 Periodically check all nuts, bolts and other fixings and tighten
where necessary.
 Have your power tool serviced by a qualified repair person
using only identical replacement parts. This will ensure that the
safety of the power tool is maintained.
Additional Battery and Charger Safety Notes
WARNING: Li-Ion batteries, if incorrectly used, stored or charged
are a fire, burn and explosion hazard.
Use the battery charger correctly
 Refer to the section of this manual relating to use of the battery
charger before attempting to charge the battery.
 When battery pack is not in use, make sure the battery pack
cannot be shorted accidentally. Keep the battery clean at all
times. Keep it away from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal objects that can
make a connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
 Allow batteries to cool for 15 minutes after charging or heavy
use. Failure to follow these instructions may cause overheating
or fire.
 Use power tools only with specifically designated battery
packs. Use of any other battery packs may create a risk of
injury and fire.
 The unit is designed for operation in altitudes of up to 2000 m
above sea level.
 Keep the battery out of reach of children.
 When not in use batteries should be stored at room tempera-
ture (approximately 20˚ C).
 Do not open, disassemble, crush, heat above 60° C or
incinerate. Do not dispose of in fire or similar.
Safety Notes
13