Emptying the Dirty Water Tank
Go to support.BISSELL.com for a full list of how-to videos.
1.
Press the button on top of
the tank, grab the front handle
and pull the tank out.
Using the Storage Tray & Clean Out Cycle
Visit support.BISSELL.com to watch additional how-to videos.
Note: The Clean Out Cycle can be run in the storage tray or on sealed hard floors.
1.
Align arrows on the storage
tray with arrows on the brush
roll drying tray and slide into
place.
4.
To begin the self-cleaning
cycle, press and hold the Area
Rug / Clean Out Cycle button
for 3 seconds.
ATTENTION
rugs. Stalling the brush may result in premature belt failure.
6 BISSELL.com
2.
Hold the top of the tank
near the sides of the filter and
pull up to remove.
2.
Make sure there is enough
solution in the clean water
tank to run the self cleaning
cycle. Empty the dirty water
tank prior to starting the self-
cleaning cycle.
5.
The Clean Out Cycle will run
for 40 seconds. Note: To stop
or pause the cycle, press the
Area Rug / Clean Out Cycle
button. Press again within one
minute to continue.
Do not overwet carpet or hardwood floors. Be careful not to run over loose objects or edges of area
3.
Pour dirty water down the
sink and rinse the tank.
3.
FreshStart™
Optional: Add
Clean-Out Formula
line on tray.
6.
Once the clean out cycle
has completed, empty the
dirty water tank and follow the
after-cleaning care steps on
page 7.
to max fill