Emptying The Dirty Water Tank - Bissell POWERCLEAN TURBOBRUSH PET XL Quick Start Manual

Emptying the Dirty Water Tank

For helpful how-to videos about maintaining your machine visit support.BISSELL.ca.
1. Pull Dirty Water Tank up 2. For quick empty: Pull the
and away to remove. rubber tab (located in the
middle of the tank) and tilt to
pour. When closing the rubber
tab, make sure all edges are
sealed tight.
4. 5.
Clean the red filter below To replace Dirty Water Tank
the Dirty Water Tank by wiping angle it by placing the bottom
off any remaining dirt or in first. Then, tilt it toward the
debris. machine and push it until it
"clicks" into place.
WARNING
To reduce the risk of fi re, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
8 BISSELL.ca
3. For final clean and rinse:
Unscrew the ring at the bottom
of tank. Gently remove the
float stack, rinse and return to
the tank lining up the arrows
locking into place. Return the
ring and twist to lock.