Emptying The Dirty Water Tank; Using The Self-Clean Cycle - Bissell BGFW13 Manual

Cleaning Your Floors (continued)
4.
Hold the trigger to apply
solution on forward and
backward passes. For tough
messes, hold the machine over
the mess and use short passes.

Emptying the Dirty Water Tank

1.
Press the button on top of
the tank, grab the front handle
and pull the tank out.

Using the Self-Clean Cycle

1.
Turn power OFF. With
handle in upright position,
press the self-clean button.
The indicator light will blink
for 60 seconds while clean
solution is dispensed. Floor
washer will shut off when cycle
is complete. Empty dirty water
tank when finished.
ATTENTION
rugs. Stalling the brush may result in premature belt failure.
5.
Release the trigger and
make a backward pass without
dispensing solution. To dry
floors faster, make additional
dry passes.
2.
Hold the top of the tank
near the sides of the filter and
pull up to remove.
2.
Press the self-clean button
again. The machine will run
two cycles:
15 second wash cycle: LED
lights on foot turn ON. Solution
will flow on brush roll.
45 second dry cycle: LED
lights on foot turn OFF. No
solution flowing on brush roll.
Do not overwet carpet or hardwood floors. Be careful not to run over loose objects or edges of area
6.
When finished, press the
power button to turn machine
OFF.
3.
Pour dirty water down the
sink and rinse the tank.
3.
Machine will shut off when
self-cleaning is complete.
Repeat as necessary.
4.
Empty dirty water tank
when finished.
BISSELLcommercial.com 5