Installation Instructions - Sharp YB-S6192AE Original Instruction

INSTALLATION INSTRUCTIONS

WARNING: Always keep the caution sheet (SPECIAL INSTRUCTIONS AND WARNINGS) close to the oven for your reference.
1) Remove all packing materials from the inside of the oven
cavity. Remove all the blue protective fi lm from the outside
of the oven.
2) Check the oven carefully for any signs of damage.
3) Place the oven on a fl at, level surface strong enough to
support the oven's weight plus the heaviest item likely to
be cooked.
Do not place this oven in a position which is not easily
accessible. To position the oven too high can be dangerous
because food can not be removed safely.
4) Ensure there is a minimum free space to install the oven.
See the fi gure A.
Figure A
13 cm or more
5) Securely connect the plug of the oven to a standard earthed
(grounded) household electrical outlet.
6) Two same oven models can be installed together by placing
one on top of another. Follow these instructions.
A. Place oven A in the desired location. Position Oven B
on top of Oven A as shown in the fi gure B.
B. Remove Screws (a) and Mounting plates A and B.
C. Replace Screw (a) of Mounting plate A removed at
step B and tighten it.
D. Remove Screws (b) and (c), then install Mounting
plate A and B which were removed at step B to
the each lower edge of Oven B as shown in the fi gure
B.
NOTE: Turn over the Mounting plates when installing.
E. Replace Screws (b) and (c) which were removed at
step D and tighten them.
F. Replace Screw (a) of Mounting plate B removed at
Figure B
Oven B
(Back)
Screw (a)
Mounting
plate B
Screw (b)
Oven A
(Back)
Mounting
plate A
Screw (a)
10 cm or more
(from upper face
of main unit)
10 cm or more
Screw (c)
EN-5
step B and tighten it.
WARNING:
In case where two ovens are installed together by placing one
on top of another,
1) Use the two mounting plates for fi xing the two ovens.
2) Make sure that the power supply cord is not caught between
the two ovens.
3) Do not install more than one oven on top of another.
4) Do not lose the removed screws.
Insert a mounting plate between
the exhaust cover and the back
plate, and tighten it with two
screws.
Back plate
Exhaust cover