Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity, ( do not remove the waveguide cover ) , and the feature
sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned
door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is any
damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED
BY SHARP and repaired, if necessary.
2. Accessories provided
1 ) Turntable 2 ) Roller stay 3 ) Operation manual and Cook book
3. Place the roller stay on the oven floor, then place the turntable on to the roller stay, ensuring it is located
firmly. Refer to OVEN DIAGRAM on page 6. NEVER operate the oven without the roller stay and
4. turntable.This oven can be installed in the locations indicated by the following "checkmarks".
Installation location example
Installation image
Presence or absence of
check mark
Standard conformity number
This oven is designed to be used on a countertop, on a shelf, in a cabinet or built-in with a Sharp built-in
kit EBR-45ST. It should not be installed in any area where excessive heat and steam are generated, for
example, next to a conventional oven unit. The oven should be installed so as not to block ventilation
openings. When the oven is mounted on a kitchen countertop, allow a space of at least 15cm on the top,
10cm on both sides and 5cm at the rear of the oven for adequate air circulation.
Additionally, when installing on a shelf or in a cabinet, the minimum dimension of the shelf or cabinet
should be 753mm ( W ) ×476mm ( H ) ×504mm ( D ) . This oven must be operated with cabinet door open. When
building the oven into a cabinet or wall, a Sharp built-in kit model number EBR-45ST is available which
enable the microwave oven to be integrated within a kitchen. Please check with your retailer for
availability. Read carefully the installation instructions for the built-in kit before installation.
Do not build-in the oven under the countertop or any other appliances. These built-in kits have been
tested according to Australian/New Zealand Standards AS/NZS60335. Sharp does not recommend the
use of any other built-in kit.
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an
emergency.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230-240V, 50Hz.
6. This appliance must be earthed.
7. Operate the oven from a general purpose domestic outlet. If a generator is used, do not operate the oven
with non-sinusoidal outputs.
Countertop
On a Shelf
5
In a Cabinet
( AS/NZS60335 )
Built-In
Advertisement
Table of Contents
