Audible Signal Sound Setting - Sharp YB-S6192AE Original Instruction

AUDIBLE SIGNAL SOUND SETTING

You can check 4 kinds of sound settings, and customize them.
1. Sound Volume
2. Sound Pattern of Cooking Completion Alarm
3. Sound Pitch of Cooking Completion Alarm
4. Sound Pitch of Filter Cleaning Reminder
There are several options in each
setting, which are shown as a
number under MEMORY indicator.
EX: Sound Volume
(2: Medium)
* Suppose you want to check or customize the status of all
audible signal sound settings.
Procedure
1 Set the oven L (unlocked).
Close the door.
2 Press the SET MEMORY pad.
<< Sound Volume >>
3 Press the START
pad repeatedly until
the desired setting is
displayed.
4 Press the SET MEMORY
pad to save the setting.
5 Press the START pad within 3 seconds to
proceed to the next setting.
<< Sound Pattern of Cooking Completion Alarm >>
6 Press the START
pad repeatedly until
the desired setting is
displayed.
7 Press the SET
MEMORY pad to save
the setting.
Display
The number 0 to 3 will
appear under MEMORY
indicator.
2 = Factory Setting
0 : Mute
1 : Small
2 : Medium
3 : Large
The number 1 to 5 will
appear under MEMORY
indicator.
5 = Factory Setting
1 : 3 short beeps
2 : Short beeps, repeating
for 1 min.
3 : A beep for 3 sec., then 3
short beeps after 30 and
60 sec.
4 : A beep for 4 sec., then 3
short beeps after 30 and
60 sec.
5 : A beep for 5 sec., then 3
short beeps after 30 and
60sec.
EN-13
8 Press the START pad within 3 proceed to the next
setting.
<< Sound Pitch of Cooking Completion Alarm >>
9 Press the START pad
repeatedly until the desired
setting is displayed.
10 Press the SET MEMORY
pad to save the setting.
11 Press the START pad within 3 seconds to proceed to
the next setting.
<< Sound Pitch of Filter Cleaning Reminder >>
12 Press the START
pad repeatedly until
the desired setting is
displayed.
13 Press the SET MEMORY
pad to save and exit the
setting.
NOTE :
To change the Program Lock Setting, see page EN-11.
The number 1 to 3 will
appear under MEMORY
indicator.
3 = Factory Setting
1 : Low
2 : Medium
3 : High
The number 1 to 3 will
appear under MEMORY
indicator.
3 = Factory Setting
1 : Low
2 : Medium
3 : High