Gdl 59 Wi-Fi Data Link Functional Check; Gsr 56 Satellite Receiver Functional Check - Garmin G1000 Nxi System Maintenance Manual

GDL 59 Wi-Fi Data Link Functional Check

This check verifies GDL 59 Wi-Fi Data Link interface is configured and is functional. This check
requires an operating and available wireless network to be within range of the aircraft.
This check only verifies the data output from the G1000 equipment. Any
equipment/wiring added that is not part of the installation data will need
separate testing and verification not covered as part of this document.
1. Start the G1000 System in Normal Mode.
2. Using the large FMS knob, select the Aux page group on the MFD. Using the small FMS
knob, select the Aux-Maintenance Wi-Fi Setup page.
3. Press the AVAIL softkey on the MFD to display the available Wi-Fi networks.
4. Press the FMS knob on the GCU to activate the cursor and rotate the small FMS knob to
highlight the desired network in the Available Networks field.
5. Press the Connect softkey on the MFD to connect to the network. (Skip to step 11 if the
selected network is a non-secure network.)
6. If the selected network is a secure network, enter the pass code in the Enter Passphrase
field in the WPA Security Settings pop-up window.
7. Press the ENT key on the GCU to accept the pass code, then press the ENT key on the
GCU again.
8. When the Save Settings pop-up window is displayed, press the ENT key on the GCU
keypad to select Save Connection.
9. Enter the airport identifier in the Airport field, then press the ENT key on the GCU to
accept the identifier.
10. With the Connect button highlighted, press the ENT key on the GCU to connect to the
network.
11. Press the ENT key on the GCU if the verification window "Are you sure you want to
connect?" is displayed.
12. Verify that the Connection Status field on the Aux – Maintenance Wi-Fi Setup page on
the MFD indicates Connected.
13. If no other service is to be performed, continue to the return-to-service checks in Section
9.

GSR 56 Satellite Receiver Functional Check

1. Power up the PFD1 in configuration mode.
2. On the PFD1, select GDL page group using the large FMS knob.
3. Using the small FMS knob select the GSR56 Configuration page. Verify the page can be
displayed and information is available.
G1000 NXi System Maintenance Manual
King Air 300 Series
190-00716-N1
NOTE
Page 369
Revision 1