Thomas & Betts COMFORT CRIMP SHURE STAKE ERG2 Manual

ERG2 SHURE STAKE
For Installing European Style Ferrule Terminals
IMPORTANT: Read and understand all of the instructions
and safety information in this manual before operating or
servicing this tool.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
In the event the SHURE STAKE
1.0
1.1

Die Set Installation

DIE
SCREWS
Figure 2
1. Remove die screws from frame with screwdriver.
2. Insert die set into frame so that larger wire size nests
are closer to the main axle of the frame. The die
screw holes in the die set should align with the die
screw holes in the frame.
3. Install die screws, close handles and tighten screws
with a screwdriver. Make sure the dies are properly
aligned.
COMFORT CRIMP
®
MECHANISM must be released, please see Figure 4.

INSTRUCTIONS FOR USE

®
®
TOOL
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
For Use With European
1.2
Style Ferrule Terminals
1. Open handles fully.
2. Position ferrule and wire subassembly into proper
nest.
3. Close handles until the SHURE STAKE® mechanism
cycle has been completed.
Figure 1
Figure 3
TA01427 B Page 1 of 2