Advertisement
For Installing STA-KON
IMPORTANT: Read and understand all of the instructions
and safety information in this manual before operating or
servicing this tool.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
In the event the SHURE STAKE
1.0
1.1
1. Open handles
fully.
2. Depress wheel
release button
and rotate
wheel to proper
die nest. Allow
wheel to lock
into position by
releasing button.
COMFORT CRIMP
ERG2008 SHURE STAKE
#8-1/0 AWG, TUBULAR ONLY
®
MECHANISM must be released, please see Figure 4.
INSTRUCTIONS FOR USE
For Use With STA-KON
Figure 2
®
Tool
®
Non-Insulated Terminals
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
®
Non-Insulated Terminals
3. Insert stripped
wire into
connector
and position
assembly in the
tool as shown.
4. Close handles
until the SHURE
®
STAKE
mechanism
cycle has been
completed.
5. Perform two
equally spaced
crimps on each
terminal barrel.
®
Figure 1
Figure 3
TA02406 D Page 1 of 2
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Thomas & Betts COMFORT CRIMP SHURE STAKE ERG2008
Summary of Contents for Thomas & Betts COMFORT CRIMP SHURE STAKE ERG2008
- Page 1 ® COMFORT CRIMP ® ERG2008 SHURE STAKE Tool ® For Installing STA-KON Non-Insulated Terminals #8-1/0 AWG, TUBULAR ONLY IMPORTANT: Read and understand all of the instructions and safety information in this manual before operating or servicing this tool. WARNING WARNING KEEP ALL BODY PARTS AWAY FROM DIE NEST HANDLES ARE NON-INSULATING.
- Page 2 ® SHURE STAKE Mechanism WARNING KEEP ALL BODY PARTS AWAY FROM DIE NEST DURING GAGING OR CRIMPING PROCEDURE. To release the SHURE STAKE mechanism, push up on the release bar until the Figure 4 ratchet teeth are disengaged. Maintenance 1. Remove dust, moisture, and other contaminants with a clean brush or a soft, lint-free cloth. 2.
Need help?
Do you have a question about the COMFORT CRIMP SHURE STAKE ERG2008 and is the answer not in the manual?
Questions and answers