Thomas & Betts Stakon COMFORT CRIMP ERG4005 Quick Start Manual

ERG4005 COMFORT CRIMP
COMPRESSION TOOL WITH SHURE STAKE
Disconnects, and Splices 16-6 AWG (8 and 6 AWG Tubular Style Only)
IMPORTANT:
information in this manual before operating or servicing this tool.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
(16-14) B NEST
(12-10) C NEST
In the event the SHURE STAKE
1.0
1.1
For Use With Non-Insulated Terminals
and Disconnects, 16-6 AWG
1. Open handles fully.
2. Insert terminal into proper
nest as shown in Figure
2, with terminal barrel
seam facing indentor.
3. Close the handles slightly
to secure the terminal. Do
not deform the terminal.
4. Insert stripped wire.
5. Close handles until SHURE
STAKE mechanism cycle
®
has been completed.
TA04530 B Page 1 of 2
TM
For Installing Non-Insulated Terminals,
Read and understand all of the instructions and safety
16-14 12-10 8-6
C DE
B
Model No.
(8-6) D-E NEST
mechanism must be released, please see Figure 5.
®

INSTRUCTIONS FOR USE

Figure 2
®
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
1.2
For Use With Non-Insulated
Splices 16-6 AWG
1. Open handles fully.
2. Splices requires two crimps.
Position splice in proper nest
as shown in Figure 3 with
window facing indentor.
3. Close handles slightly to
secure terminal. Do not
deform terminal.
4. Insert stripped wire.
5.
Close handles until
the SHURE STAKE
mechanism cycle has been
completed.
6.
Repeat steps 2-5 on
opposite end of splice.
®
MECHANISM
Figure 1
®
Figure 3