Startup / Operation - BOMANN GS 365 Instruction Manual

Prior to first use Prior to first use Prior to first use Prior to first use
CAUTION CAUTION CAUTION CAUTION: : : :
After transport, the appliance should be left standing upright for about 4 hours before connecting to the power
supply. Nonobservance could lead to malfunction of the cooling system and causes a breakdown of the appli-
ance.
Clean the interior of the appliance including all accessory parts located inside. Consider the instructions which
we provide in the chapter "Cleaning".
Starting the appliance Starting the appliance
Starting the appliance Starting the appliance
• Switch on by connecting the appliance to the power supply.
• Operate the temperature control, which is located at the appliance front. See also the following section
"Settings".
Settings Settings
Settings Settings
The power levels 1 – 4 regulates the different values of the internal temperature.
Setting 1
Setting
•
Setting 4
Turning the temperature control clockwise will lower the inside temperature. Keep in mind that the tempera-
ture will change depending on the ambient temperature (of the location), the frequency of door opening and
the amount of food in the appliance.
During initial operation, turn the temperature control to the highest setting first, until the appliance has reached
the desired operating temperature. Afterwards it is recommended to turn the control back to a medium setting;
correcting the temperature at a later point would then be easier.
Storing food Storing food
Storing food Storing food
The freezer allows you to store frozen food at a temperature of -18°C or below (from a middle tempera-
ture control setting) for several months, to produce ice cubes and to freeze fresh good. Due to external influ-
ences such as room temperature, placements, frequency of opening the door and the amount of food the
temperature in the freezer can be influenced.
Freezing Freezing Freezing Freezing
• 24 hours before freezing we recommend turning the temperature control to the highest power level and to
keep this setting even after freezing for a few hours. The appliance is not compromised if the setting will
not revert to a normal operating temperature after the freezing process, but for economic reasons you
should possibly avoid it.

Startup / Operation

Startup / Operation
Startup / Operation Startup / Operation
lowest setting (warmest inside temperature)
off state
highest setting (coldest inside temperature)
21