Connection Of Digital Signal Sources; Rc 3 Remote Control - AVM OVATION CD 6.3 Operating Instructions Manual

1.6 Connection of digital signal sources

Digital signal sources
Connect the outputs of your digital sources to the corresponding inputs of your device:
- Optical inputs (23, 24)
- Coaxial inputs (25, 26)
- USB B input (22)
- AES/EBU input (27)
Digital input sources
The input of a digital recorder must be connected to the digital outputs (20, 21). The signal on
the digital outputs depends on the selected source (e.g. DIG COAX, DIG OPT).
PLEASE NOTE: Incoming signals via the USB-B input (22) are not looped through the digital
outputs (20).

1.7 RC 3 remote control

The included RC 3 remote control allows for easy and comprehensive control of your device.
All main functions can be controlled by the RC 3: On/Off, Source Selection, Station
Selection, SKIP, PLAY/PAUSE, and STOP.
By pressing the PLAY button briefly a second time, the PAUSE function is activated while in
CD mode. By pressing the STOP button briefly a second time, an inserted CD is ejected. By
holding down one of the SKIP buttons a little longer, the device switches into seek mode
(Fast Forward/Reverse).
If there is no CD inserted or the CD is not in playback mode, you can switch between the
different digital inputs by pressing the STATION buttons of the RC 3. Press PLAY to return to
CD mode.
If a variable output level has been activated in the personal setup menu (see 3.1.1), you can
control the output level of the analogue outputs of your CD 3.2 / CD 5.2 by pressing the
VOLUME buttons on your RC 3 remote control (see also 2.6).
8