Switching On/Off; Use As Screwdriver; Drilling Masonry And Concrete - Westfalia ASBS 18 Original Instructions Manual

Switching ON/OFF

WARNING: Always wear adequate personal protection equipment
when setting up and operating this machine.
To start the tool, squeeze the trigger switch (8).
Note: If the trigger switch cannot be pressed down, check that the
forward/reverse switch (7) is not set to its middle position, which locks
the device (see 'Direction control').
 The speed of the tool is controlled by the movement of the trigger,
the further the trigger switch is pressed down, the faster the tool will
run.
 Release the trigger switch to stop the machine.
 The work light (9) turns on while the trigger switch is pressed.

Use as Screwdriver

Note: Always use a universal bit holder when working with screwdriver
bits. Do not mount screwdriver bits directly into the chuck!
1. Select gear 1 using the gear switch (5).
2. Rotate the mode selector (4) to drive.
3. Adjust the combi drill to the appropriate torque setting (see 'Torque
Control').
 When driving screws never use the machine in drill mode.
Note: If in doubt which torque setting best suits the application, start
with a low setting and increase, should more torque be required (e.g. if
the screw is not being driven far enough into the workpiece).

Drilling Masonry and Concrete

1. Select gear 1 using the gear switch (5).
2. Rotate the mode selector (4) to the hammer drill position.
 Hammer drill mode should be used for drilling into masonry and
concrete.
 Apply moderate pressure to the rear of the tool, in line with the drill
bit.
 Use masonry drill bits only. Ensure that the bit size is within the
maximum capacity of the machine (see 'Technical Data').
Operation
24