Table of Contents
Advertisement
MTL01
2.
INSTALLATION
Before inserting an ISA-Bus modem into the terminal, a COM serial port and an interrupt must be set
through the dip-switches and/or jumpers on the card. The Terminal will be able to interface the modem
using the COM and IRQ resources.
The same concept is used also for Terminals with Operating System: in this case MTL01 is detected as a
serial port; this means that, during the installation it is important to detect the new COM port.
After the installation, you can configure the modem using AT commands or a Windows" driver (Standard
Modem).
For the hardware installation, please follow this procedure:
Remove the modem from its package, and check it is OK.
Set the dip-switch with COM port and IRQ (see table below).
Switch-OFF the Terminal, then insert the modem in a free ISA-Bus slot.
Fix the card modem and close the Terminal.
Insert the phone line cable using the one supplied in the package.
Once the installation of the serial port is over, you can start with the modem configuration using AT commands.
2.1.
INSTALLATION - WINDOWS®
Windows® sees MTL01 as a serial port, so you must look for a free COM and IRQ in the Operating System,
then set a COM and IRQ in MTL01.
Select the System utility in the Control panel, then select the Hardware folder and click the Device manager
button. In the most recent Operating Systems use the System Information utility present in Programs/
Accessories/System Utility.
Now set the dip-switch and the jumper on the modem card.
If there are not free COM or IRQ, you can disable COM1 or
COM2 (if it is not used) in BIOS.
For the hardware installation, please follow this procedure:
Remove the modem from its package, and check it is
OK.
Set COM and IRQ by the dip-switch (see table below).
Switch-OFF the PC, then insert the modem in a free ISA-
Bus slot.
Fix the card modem, and close the PC.
Insert the phone line cord supplied in the modem
package.
Run Windows®: MTL01 could not automatically detect the
new serial port as it is not a Plug&Play (PnP) card. Run the
Add/Remove Hardware utility in the Control Panel and
select automatic search: Windows® will detect a new serial port.
After the serial port installation is over, you can configure the modem using AT commands, or with a Windows®
driver (Standard Modem).
2.1
Installation
Advertisement
Table of Contents
