Main Unit Parts And Functions - Teac PD-505T Owner's Manual

Main unit parts and functions

A
STANDBY/ON switch
Use this to put the unit into standby mode or turn it on.
o If the display is off even though the STANDBY/ON switch is
set to ON, the cause is usually one of the following.
o The power is on, but DIMMER (display brightness) is set to
AUTO OFF (page 19).
o The automatic power saving function has activated, put-
ting the unit into standby (page 20).
o The power cord is disconnected.
To turn the unit on when the automatic power saving
function has activated, putting the unit into standby, press
the STANDBY/ON button on the remote control, or set the
STANDBY/ON switch to STANDBY once and then back to ON.
B
CLOCK indicator
This shows the clock synchronization status.
Lit: The unit is currently synchronized with the clock
from the CLOCK sync input (10MHz IN) connector.
Blinking: No clock is being input, or the unit is trying to
synchronize with the clock signal.
Unlit:
External clock is not being used.
o See page 19 for clock sync settings.
C
Remote control signal receiver
This receives signals from the remote control. When operat-
ing the remote control, point it at the remote control signal
receiver.
D
Disc tray
Load a disc here.
E
Display
This display shows information about the audio playing back
and menu screens.
F
Tray open/close (-) button
Press this to open and close the disc tray.
12
G
Stop (8) button
Press this to stop playback.
H
Play/pause (7/9) button
Press this when stopped or paused to start or resume playback.
Press this during playback to pause.
When the menu screen is open
Press this to start or confirm setting value selection.
I
MENU button
Press this to enter setting mode (page 18).
Press this when in setting mode to return to the previous
screen.
J
Skip (.//) buttons
Use these to skip to the previous or next track.
Press and hold these buttons during playback to search back-
ward/forward (page 15).
When the menu screen is open
Use these to select setting values.