AEG HC452601EB User Manual page 35

• Seal the gap between the worktop
and glass ceramic with silicone.
• Put some soapy water on the silicone.
• Pull off the excess silicone with the
scraper.
8.6 Installation of more than
one hob
Supplied accessories: connection bar,
heat-resistant silicone, rubber shape,
sealing stripe.
Use only a special heat-
resistant silicone.
The worktop cutout
Distance minimum 50 mm
from the
wall
Depth 490 mm
Width sum of all widths of hobs that
you install minus 20 mm
Example:
+
580 mm 360 mm
Assembly
1. Calculate correct cutout dimensions.
2. Prepare cutout in the worktop.
min.
25 mm
min.
2 mm
- =
20 mm 920 mm
3. One by one place the hobs on a soft
surface (for example on a blanket)
with the bottom side up.
4. Attach the supplied seal stripe to the
lower edge of the hob along the
outer edge of the glass ceramic.
5. Loosely screw the fixing plates into
the correct holes in the protective
casing.
6. Insert first hob into the worktop
cutout. Than insert the connection
bar into the worktop cutout. Push it
half of its width under the hob.
7. Loosely screw in the fixing plates
from below to the worktop and to
the connection bar.
8. Insert next hob into the worktop
cutout. Make sure that the front
edges of the hobs are on the same
level.
ENGLISH 35