Charging The Unit - Sony DRC-BT30 Operating Instructions Manual

Charging the unit

The unit contains a rechargeable Lithium-Ion battery, which should be charged
before using for the first time.
1
Open the cover of the  USB
connector.

Connect the supplied USB cable
to the unit, and then connect
the other end to a computer.
When connecting, insert the
connector with  facing down.
Charging starts when the unit and
the computer are connected.
Make sure that the indicator (red)
lights up. Charging is completed in
about 2.5 hours* and the indicator
(red) goes off automatically.
* Time required for empty battery to
recharge.
8
GB
Notes
 If this unit is not used for a long time, the
indicator (red) may not light up when you
connect the USB cable to charge this unit.
In this case, do not disconnect the USB
cable from the unit and wait until the
indicator (red) lights up.
 When you close the cover of the  USB
connector after charging, push the cover
thoroughly until the tab is full inserted.
 For system requirements for a personal
computer that can charge the battery using
USB, see "System requirements for battery
charge using USB" (page 27).
Tips
 If the USB cable is connected to a
computer while the unit is turned on, the
unit will be turned off automatically.
 This unit cannot be turned on while
charging.