Pairing; What Is Pairing; Procedures Of Pairing - Sony DRC-BT30 Operating Instructions Manual

Pairing

What is pairing?

Bluetooth devices need to be "paired"
with each other beforehand.
Once Bluetooth devices are paired,
there is no need for pairing again,
except in the following cases:
 Pairing information is deleted after
repair, etc.
 When you attempt to pair with 9 or
more devices.
This unit can be paired with up to 8
devices; if a new device is paired
after 8 devices have been paired, the
device whose latest connection time
is the oldest among the 8 paired
devices is replaced by the new one.
 When recognition of the unit by the
device to be connected is deleted.
 This unit is initialised (page 25). All
pairing information is deleted.
10
GB

Procedures of pairing

1
Place the Bluetooth device
within 1 m of this unit.

Open the cover of the  USB
connector.
Press and hold the PAIRING
button for  seconds or more to
standby for pairing while the
unit is turned off.
The indicator (blue) and indicator
(red) flash in turn and the unit
enters into pairing mode.
Note
If pairing is not established within about
5 minutes, pairing mode will be
cancelled and this unit will turn off. In
this case, start over from step 1.