Siemens SIMATIC NET S7-300-PROFIBUS CP 342-5 Equipment Manual page 49

ATEX / IECEx / UKEX / CCC-Ex
Note the information in the document "Use of subassemblies/modules in a Zone 2 Hazardous
Area", which you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
The conditions must be met for safe usage of the product according to the section Notes on
use in hazardous areas according to ATEX / UKEX / IECEx / CCC-Ex (Page 33).
Observe installation guidelines
The product meets the requirements if you observe the following during installation and
operation:
• The notes in the section Installation, wiring, commissioning, removal (Page 33)
• The installation guidelines in the document /2/ (Page 54)
The product meets the explosion protection requirements outlined below.
IECEx
Classification: Ex ec IIC T4 Gc, Certificate no.: IECEx DEK 18.0019X
The product meets the requirements of the standards:
• IEC 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
• IEC 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety 'e'
ATEX
Classification: II 3G Ex ec IIC T4 Gc, Certificate no.: DEKRA 18ATEX0027 X
The product meets the requirements of the standards:
• EN IEC 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
• EN 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety 'e'
UKEX
Classification: Ex ec IIC T4 Gc, Certificate no.: DEKRA 21UKEX0003 X
The product meets the requirements of the standards:
• EN IEC 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
• EN 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety 'e'
Importer UK: Siemens plc (see above)
CP 342-5
Equipment Manual, 01/2023, C79000-G8976-C146-11
WARNING
Certifications and approvals
49