Table of Contents
Advertisement
Disassembly
Removing the Hard Disk Drive
Figure 2
HDD Assembly
The hard disk drive can be taken out to accommodate other 2.5" serial (SATA) hard disk drives with a height of 9.5mm
Removal (cont'd.)
or 7mm (h). Follow your operating system's installation instructions, and install all necessary drivers and utilities (as
outlined in Chapter 4 of the User's Manual) when setting up a new hard disk.
a. Locate the harddisk.
b. Remove the screw.
Hard Disk Upgrade Process
c. Grip the tab and slide the
HDD assembly in the di-
1. Turn off the computer, turn it over, remove the bottom cover and battery
rection of the arrow.
2. The harddisk will be visible at point
d. Lift the HDD assembly
3. Remove the screw
out of the bay.
4. Grip the tab
e. Remove the screws and
5. Lift the hard disk assembly
bracket from HDD.
6. Remove the screws
7. Reverse the process to install a new hard disk (do not forget to replace all the screws and bottom cover).
a.
b.
9. HDD Bracket
10. HDD
• 3 Screws
2 - 6 Removing the Hard Disk Drive
(Figure
1
from the hard disk assembly
2
and slide the hard disk assembly in the direction of arrow
3
out of the bay
5
-
and the hard disk bracket
7
8
1
c.
2
3
(page 2 -
2a).
(Figure 2b
)
.
(Figure 2c
4
)
(Figure 2d
.
6
from the hard disk
9
10
d.
5
6
e.
8
4
5).
).
(Figure 2e
)
.
5
7
9
10
Advertisement
Table of Contents
