Husqvarna 120iBV Operator's Manual page 6

• Do not run with the product.
• The powerful currents of air can move objects at
such a speed that they can bounce back and cause
serious eye injuries.
• Do not direct the airflow towards people or animals.
• Stop the motor before you assemble or dismantle
accessories or other parts.
• Keep all parts of your body away from hot surfaces.
• Never put the product down when it is activated
unless you have it in clear sight.
• Stop the machine, and remove the battery. Make
sure that all moving parts have come to a complete
stop:
• whenever you leave the machine
• before clearing blockages or unclogging chute
• before checking, cleaning or working on the
machine
• Immediately shut off the power source and allow
the machine to stop if the cutting mechanism hits
any foreign objects or if the machine should start
making any unusual noise or vibration. Disconnect
the battery from the machine and take the following
steps before restarting and operating the machine:
• examine for damage
• replace or repair any damaged parts
• check for and tighten any loose parts
• Shut off the power source and disconnect the
machine from battery before cleaning unwanted
material if the machine becomes clogged.
• Do not transport this machine while the power
source is running.
• Do not tilt the machine while the power source is
running.
6
• The blower must not be used while on a ladder or
scaffolding.
• Do not use the product unless you are able to call for
help in case of an accident.
• Watch out for thrown objects. Stones, rubbish, etc.,
can be thrown up into the eyes causing blindness or
serious injury.
• Use a residual-current device (RCI) for increased
security when you charge the product. A residual-
current device is fitted to protect operators in case
an electrical fault should occur.
• This product is renowned for its low vibration load.
Overexposure to vibration can lead to circulatory
damage or nerve damage in people who have
impaired circulation. Contact your doctor if you
experience symptoms of overexposure to vibration.
Such symptoms include numbness, loss of feeling,
tingling, pricking, pain, loss of strength, changes in
skin colour or condition. These symptoms normally
appear in the fingers, hands or wrists.
• Only use the product for the purpose it was intended
for.
• It is not possible to cover every conceivable situation
you can face. Always exercise care and use your
common sense. Avoid all situations which you
consider to be beyond your capability. If you still feel
uncertain about operating procedures after reading
these instructions, you should consult an expert
before continuing.
Personal protective equipment
WARNING:
instructions that follow before you use the
product.
• Always use approved personal protective equipment
when you use the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident does
occur. Let your dealer help you select the right
equipment.
• Long term exposure to noise can result in damaged
hearing. In general, battery powered products
are relatively quiet but damage can result from
a combination of noise level and long usage.
recommends that operators use hearing protectors
when using products for a longer coherent time of
Read the warning
2034 - 002 - 17.01.2023