Simulation Mode; Simulation Mode In Profibus Pa; Simulation Mode With Foundation Fieldbus - Siemens SITRANS TH400 Operating Instructions Manual

Functions

6.4 Simulation mode

6.4 Simulation mode
6.4.1

Simulation mode in PROFIBUS PA

The simulation mode of the PROFIBUS PA has no simulation write protection.
6.4.2

Simulation mode with FOUNDATION fieldbus

Note
• To use the simulation mode in SITRANS TH400 FOUNDATION fieldbus you need a
• You can obtain this magnetic pin from technical support in the Internet at
● To switch to the software simulation mode in the SITRANS TH400 FOUNDATION
Figure 6-1
①
②
③
● As long as the device is operated in simulation mode, the magnetic pin must be located
30
special magnetic pin to enable the software simulation mode.
http://www.siemens.de/automation/support-request.
fieldbus version, place to the connecting terminals 1 and 2 on the special magnetic pin;
see the following picture.
s
2
1
6
3
3-W
-
+
5
4
Activation of reed contact in SITRANS TH400 FF
Magnetic pin
Connecting terminal
SITRANS TH400 FF
on the device.
Operating Instructions, 02/2007, A5E01018688-01
SITRANS TH400