Removing The Mower Deck - Toro 74766 Operator's Manual

C. To lower the front of the mower, loosen the
adjustment nut.
D. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip
1
Figure 60
1. Adjusting rod
2. Adjusting block
7. When the front-to-rear blade slope is correct check the
side-to-side level of the mower again, refer to
from Side to Side (page
(Figure 59).
3
2
G014634
3. Locknut
Leveling
41).

Removing the Mower Deck

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest position.
4. Remove the hairpin cotter from the front support rod
and remove the rod from the deck bracket
g014634
3
1. Front support rod
2. Locking nut
5. Carefully lower the front of the mower deck to the
ground.
6. Lift the mower deck and hanger brackets clear of
the rear lift rod and lower the mower carefully to the
ground (Figure
43
1
G014635
Figure 61
3. Deck bracket
62).
ARK
(Figure 61).
2
g014635