Table of Contents
Advertisement
Tow
This is the medium speed. The suggested uses for this speed
are as follows:
•
Bagging
•
Mulching
Mow
This is the fastest speed. The suggested uses for this speed
are as follows:
•
Normal mowing
•
Transporting the machine
Stopping the Machine
To stop the machine, move the motion-control levers to
N
and outward to the P
EUTRAL
blade-control switch, ensure that the throttle is in the F
position, and turn the key to O
switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion-control levers outward to the P
when leaving the machine unattended, even if just
for a few minutes.
position, disengage the
ARK
AST
. Remove the key from the
FF
position
ARK
Adjusting the Height of Cut
Note: The transport position is the highest height-of-cut
position at 115 mm (4-1/2 inches) as shown in
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the height
of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so that the rollers do not
touch the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the P
engage the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the anti-scalp rollers as shown in
match the closest height-of-cut position.
22
Figure
Figure 25
position, and
ARK
Figure 26
25.
g028025
to
Advertisement
Table of Contents
