Table of Contents
Advertisement
Switch position Video format
0
1920×1080p/59.94
1
No output
2
1920×1080p/29.97
3
No output
4
1280×720p/59.94
5
1280×720p/29.97
6
No output
7
VISCA CONTROL
8
1920×1080p/50
9
No output
A
1920×1080p/25
B
No output
C
1280×720p/50
D
1280×720p/25
E
1280×720p/15
F
No output
Notes
Be sure to set this switch before you turn on the power of the
camera. You can also set this switch in the standby mode of the
camera. After completing the setting, turn on the power of the
camera by connecting it to an AC outlet using the supplied AC
power adaptor and AC power cord, by using the VISCA
command or infrared remote commander.
Be sure to use a Phillips-head screwdriver when changing the
switch position. If you use a tool other than the designated
screwdriver, the crossed groove may be damaged.
Even if you set this unit to the USB3.0 output with the SYSTEM
SELECT switch, when the USB2.0 cable is used or when the
USB2.0 terminal of computer is connected, the image will not be
output.
If the switch position is set to 1, 3, 6, 9, B and F (no output), the
POWER lamp and STANDBY lamp will both remain lit. In such
cases, control via the infrared remote commander and VISCA
communication is disabled.
The set frame rate may not be output depending on the
performance and processing condition of a computer.
If the switch position is set to 7 (VISCA CONTROL), you can
configure the video format via external communication.
Setting of the BOTTOM switches
To change the BOTTOM switch setting, select the
USB3.0
BOTTOM switch with the power of this unit turned off
(not including standby state), and then turn on the DC
power. The setting cannot be changed after the power
is turned on.
—
—
ON
USB3.0
OFF
(Initial position)
VISCA/LAN switch
USB2.0
Select the communication method setting.
Set this switch to ON to use the LAN connection.
—
The switches and are ignored when using the LAN
connection.
USB Control Switch
Set this switch to ON to enable the control from computer
via USB.
During the USB control, the switch is ignored and the
baud rate is fixed to 38400.
When the USB control switch is set to ON, set the switch
to OFF.
Baud rate select switch (enabled only when using the
serial connection)
Set the switches and to OFF to use the VISCA
CONTROL (serial communication).
Set the communication speed in the VISCA CONTROL.
ON: 38,400 bps
OFF: 9,600 bps
IR OUT switch
Set to ON to enable output of the receiver signals, which are
transmitted from the infrared remote commander via the
VISCA IN connector (page 53), or set it to OFF to disable
the output.
Switch 5 (Not used)
Be sure to set this switch to OFF.
Switch 6 (Not used)
Be sure to set this switch to OFF.
Switch 7 (Not used)
Be sure to set this switch to OFF.
Switch 8 (Not used)
Be sure to set this switch to OFF.
Locations of Controls
Advertisement
Table of Contents
