3.4.7
SD Load
SD Load allows a previously saved configuration to be loaded from an SD card. The System ID and
software version must match the unit saved to the card. Before configuring, determine if a previously saved
configuration is available. Use the following instructions to load the saved configuration information to a
unit:
1. Power the unit on in Configuration mode.
2. Insert SD card into the card slot.
3. Touch the SD Load button.
4. Select a file to load.
5. Restart the unit.
6. Verify settings on Interface Settings page are correct.
190-02207-A2
Rev. 3
GPS 175/GNX 375/GNC 355 Part 23 AML STC Maintenance Manual
Page 3-11