Controls - Klark Teknik DN9848 Operator's Manual

Controls

THE INPUT CHANNELS
Each input channel comprises an input gain stage followed by an eight-band, fully parametric equaliser,
a full-band compressor and a delay. The input metering monitors the output from each processing stage
to avoid the possibility of inadvertent clipping within the processing chain.
Input block diagram:
Input
Input
Gain
PEQ 6
INPUT MENU BUTTONS
Each of the four input channels (A - D) may be accessed and edited independently via channel select
buttons A, B, C and D. These correspond directly to rear panel inputs A, B, C and D and each button has
an integral amber LED to indicate which channel is currently being accessed. Depressing any of these
buttons will provide direct access to the first page of the edit menu. Subsequent presses will step
through the five available edit pages after which the display will return to Page 1 and the sequence will
start again. The number of accessible pages is subject to the Lock status of the unit. If the System
Protection password has been set, the compressor pages will be inaccessible until the unit is unlocked.
Pressing the HOME (SETUP) button at any time during editing will return the user to the main menu
HOME page.
Pressing STORE or RECALL will also cause the operating system to leave the current menu and
initiate either the Store or Recall sequence as selected.
Pressing any Input channel select button when an output menu is currently active will quit the current
menu and go to the first menu page of the input channel selected. Similarly, pressing any Output
channel select button when an input menu is currently active will quit the current menu and go to the
first menu page of the output channel selected.
Pressing an Output channel select button when a different output channel menu is currently active will
change the display to the same page of the newly selected output channel. Pressing an Input channel
select button when a different input channel menu is currently active will change the display to the same
page of the newly selected input channel.
8
PEQ 2 PEQ 3
PEQ 1
PEQ 7 PEQ 8
PEQ 5
PEQ 4
Compression Delay
Clip
Input
Output
Metering
Metering
Input
Feed