Rear Panel Connectors - Klark Teknik DN9848 Operator's Manual

Rear Panel Connections
Both the input and output channels are accessed via electronically balanced XLR
connectors wired pin 1 ground, pin 2 hot, pin 3 cold. These may be used unbalanced
where necessary by connecting the ground and cold pins together, though balanced
operation is recommended.
Two further XLR connectors (in/out comms) carry the RS-485 interface and are
connected in parallel to facilitate the linking of multiple units. This interface facilitates
remote control and monitoring.
Mains is fed to the unit via a standard IEC type connector.
6