Lubrication; Greasing The Bearings - Toro TimeCutter MX 4250 Operator's Manual

Lubrication

Greasing the Bearings

Machines with a 107 cm (42 inch),
127 cm (50 inch), or 137 cm (54
inch) Mower Deck Only
Service Interval: Every 25 hours—Grease all
lubrication points (107 cm (42 inch),
127 cm (50 inch), or 137 cm (54
inch) Mower Deck Only).
Important:
This procedure does not apply to
MyRide models.
Grease Type: No. 2 lithium grease
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings
34) with a rag.
Note:
Make sure to scrape any paint off the
front of the fitting(s).
Figure 33
1. Front caster tire
-L
EUTRAL OCK
(Figure 33 and Figure
g032432
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check the tire pressure
every 25 operating hours.
4. Connect a grease gun to each fitting
and Figure 34).
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
35
Figure 34
3. Grease every 25 operating
hours.
4. Engine
(Figure 33
decal106-8717