Toro TimeCutter MX 4250 Operator's Manual page 26

2. To go backward, slowly pull the motion-control
levers rearward (Figure
Using the Smart Speed
System
The Smart Speed TM Control-System lever, located
below the operating position
operator a choice to drive the machine at 3 ground
speed ranges—trim, tow, and mow.
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and
outward to the P
2. Disengage the blade-control switch.
3. Adjust the lever to the desired position.
24).
Figure 24
TM Control
(Figure 25), gives the
Figure 25
position.
ARK
The following are only recommendations for use.
Adjustments vary by grass type, moisture content,
and the height of the grass.
Suggested
uses:
Parking
Heavy, wet
grass
Training
Bagging
Mulching
Normal
mowing
Transport
Trim
This is the lowest speed. The suggested uses for this
speed are as follows:
g008953
•
Parking
•
Heavy, wet grass mowing conditions
•
Training
g027625
26
Trim Tow
X
X
X
X
X
Mow
X
X