Adjusting The Anti-Scalp Rollers - Toro TimeCutter MX 4250 Operator's Manual

Adjusting the Anti-Scalp
Rollers
Machines with a 107 cm (42 inch),
127 cm (50 inch), or 137 cm (54
inch) Mower Deck Only
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
27 to match the closest height-of-cut position.
Figure 26
EUTRAL
1. Anti-scalp roller
2. Bolt
Machines with a 152 cm (60 inch)
Mower Deck Only
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
g028025
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the flange nut, anti-scalp roller, and bolt
from the bracket
Note:
together when removing.
-L
OCK
1. Flange nut
2. Spacer
3. Anti-scalp roller
4. Align the bolt and anti-scalp roller in the
Figure
hole of the bracket that matched the closest
height-of-cut position
28
Figure 27
3. Flange nut
4. Hole spacing
(Figure 28).
Keep the bolt and anti-scalp roller
Figure 28
4. Bushing
5. Bolt
(Figure
g010233
-L
EUTRAL OCK
g024312
28).