Installing And Removing The Battery Pack - DeWalt DCS571E1 Instruction Manual

Installing and Removing the Battery Pack

(Fig. I)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
4
button and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. I
Proper Hand Position (Fig. J)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
18
handle or, if the auxiliary handle is attached, one hand
18
on the main handle and one hand on the auxiliary
13
handle .
Fig. J
13
3
into the tool handle, align the
Trigger Switch (Fig. A)

WARNING: This tool has no provision to lock the
trigger switch in the ON position and should never be
locked ON by any other means.
Release the trigger switch lock-off button
the lock-off button. Pull the trigger switch
motor on. At this time you can let go of the lock-off button.
Releasing the trigger switch turns the motor off.
Dust Extraction (Fig. K, L)
Your saw has a built-in dust port
the supplied dust bag
be connected. The built-in dust port utilizes the D
AirLock connection making it compatible with the D
dust extractors.
To Attach a Dust Extractor (Fig. K)
Your D WALT circular saw is fitted with the D
e
AirLock® connection system. The AirLock® allows for a fast,
secure connection between the dust extractor and power
3
tool. The AirLock® connector
D WALT compatible tools.
4
e
1. Ensure the collar on the AirLock® connector is in the
unlock position. (Refer to Figure K.) Align notches
collar and AirLock® connector as shown for unlock and
lock positions.
2. Push the AirLock® connector onto the adapter
connector point.
3. Rotate the collar to the locked position.
nOTE: The ball bearings inside collar lock into slot and
secure the connection.The power tool is now securely
connected to the dust extractor.
Fig. K
To Attach the Dust Bag (Fig. L)
1. While holding the saw, fit the dust bag collar
dust port
18
2. Turn the collar
in place.
18
22
which allows either
25
or a shop vacuum system to
23
connects directly to
24
23
22
as shown in Figure L.
26
clockwise to lock the dust bag
English
1
by pressing
2
to turn the
WALT
e
WALT
e
WALT
e
24
on
24
26
to the
25
11