Table of Contents
Advertisement
Available languages
Available languages
nOTE: For optimal results, allow the saw blade to protrude
from the workpiece by about 1/8" (3 mm) (Fig. F).
Fig. F
8
Wireless Tool Control (Fig. A)
(Available on some units)
CAUTION: Read all safety warnings, instruction and
specifications of the appliance which is paired with
this tool.
This tool is equipped with a Wireless Tool Control transmitter
which allows it to be wirelessly paired with another Wireless
Tool Control device, such as a dust extractor.
To pair your tool using Wireless Tool Control, press and
hold the on/off switch
1
and the Wireless Tool Control
pairing button on the separate device. An LED on the
separate device will let you know when your tool has been
successfully paired.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. A1)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
14
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
and firmly pull the battery pack out of the tool
15
handle. Insert it into the charger as described in the charger
section of this manual.
4
into the tool handle, align the
Proper Hand Position (Fig. G)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the front
handle
11
, with the other hand on the main handle
Fig. G
3
Instructions for Use
WARNING: Always observe the safety instructions
and applicable regulations.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Switching On and Off (Fig. A1)
Press the on/off switch
to turn the track saw on.
2
Guiding the Tool (Fig. A1, G, H)
WARNING:
•
ALWAYS secure the workpiece in such a manner
that it cannot move while sawing.
ALWAYS push the machine forward. NEVER pull
•
the machine backward towards you.
•
ALWAYS use the track saw with both hands.
Put one hand on the main handle
second hand on the front handle
in Figure G.
•
ALWAYS use the clamp to hold the rail to
the workpiece.
•
Use proper hand position to guide the saw properly.
•
The cutting indicator
27
and 47° cuts (without guide rail).
•
The blade position indicator
position for full plunge.
•
For optimum results, clamp the workpiece bottom up.
English
3
.
11
3
and the
11
as shown
displays the cutting line for 0°
29
shows the blade
11
Advertisement
Table of Contents
