7.2.2 Logging In to the CLI of OM Module
1. Prerequisites
•
Power on the chassis.
•
Obtain the login data of the OM module. The default login data of the OM CLI is shown in
Figure
7-3.
2. Procedures
(1)
Connect the Ethernet port of the PC to the "MGMT" port of the primary and backup OM
modules via LAN, as shown in
module are accessible on L3.
Figure 7-3 Setting up the hardware environment
PC
(2)
Set the login parameters and log in to the OM CLI using the remote access software.
7-3
lists the login parameters.
Table 7-2 SSH login parameters
Protocol
Port number
Management IP address of the OM module
User name and password used to log in to the
OM module
•
The SSH access mode is enabled for the OM module by default.
(1)
After login, the OM CLI displays the login page, as shown below.
******************************************************************************
Figure
LAN
Parameter
7-3. Ensure that the IP addresses of the PC and OM
SSH
22
•
Management IP address (default):
192.168.100.100
•
Subnet mask (default): 255.255.255.0
•
User name (default): admin
•
Password (default): Password@_
7-4
Enclosure
Value
Figure