Table of Contents
Advertisement
7
Configuring the Cascading Module
7.1 Port Rate Switching
7.1.1 Changing Through the OM Web UI
You can switch the port rate of the cascading module on the OM Web page.
1. Prerequisites
Before switching the port rate of the cascading module on the OM Web page, ensure that the
following work is completed:
•
The cascading module has been powered on. For details, see
Straight-Through
•
Log in to the OM web: See
2. Procedures
(1)
Click Interconnection Module Management, select the target cascading module, and click
Port Mapping > External Port.
(2)
In "Port Mapping View", select the external port of which the port rate is to be changed.
(3)
In the "Rate Configuration" parameter column, select a required port rate, and click "OK" to
complete the rate change.
Notes
•
Please set the rate of the matching external port of the cascading module according to the
rate of the optical module. Otherwise, the status of the external port of the cascading module
cannot be "UP". For example, when an external port is installed with a 10G optical module,
the external port rate needs to be set to 10G.
•
For BT1004E, if the rate of one port is switched, the OM module will automatically switch the
rates of the four ports in the same group.
•
When the rate of a port is set to "auto", the port will, based on the optical module it identifies,
automatically switch to a port rate that is the same as the optical module.
•
By default, the port rate of BT1004E is configured as Auto.
7.1.2 Changing Through the OM CLI
Run the port-speed command to switch the port rate of the cascading module on the OM CLI
page.
1. Prerequisites
Before switching the port rate of the cascading module on the OM CLI page, ensure that the
following work is completed:
•
The cascading module has been powered on. For details, see
Straight-Through Module.
Module.
7.1.1 Logging into the OM
Web.
7-1
5.1 5.1 Powering On the
5.1 Powering On the
Advertisement
Table of Contents
