Edge-Core SAF51001I Quick Start Manual

Quick Start Guide
Network Security Platform
SAF51001I
1. Network Security Platform SAF51001I
2. Four adhesive foot pads
3. AC/DC Power Adapter
Note: The device is an open platform with Ubuntu Linux
pre-installed, but no application software.
1

Desktop Mount the Device

1. Attach the four rubber foot pads to the base of the device, and
then place it on a desktop or shelf.
2

Ground the Device

1
1. Ensure the device is properly grounded in compliance with ETSI
ETS 300 253. Verify that there is a good electrical connection to
the grounding point (no paint or isolating surface treatment).
2. Attach the grounding wire (#14 AWG) to the grounding point
on the device rear panel. Then connect the other end of the wire
to ground.
Caution: The earth connection must not be removed unless
all supply connections have been disconnected.
www.edge-core.com
1
1
2

Package Contents

2
4. Power Cord—either Japan, US, Continental Europe or UK
5. Console Cable—RJ-45 to DB-9
3

Connect Power

1
2
1. Connect the AC/DC power adapter to the DC jack on the
device.
2. Connect the AC/DC power adapter to an external AC power
source.
4

Verify Device is Powered On

1
1. Verify the device is powered on by checking the PWR LED.
When operating normally, the PWR LED should be on green.
5

Connect Network Cables

1. For the RJ-45 ports, connect 100-ohm Category 5, 5e or better
twisted-pair cable.
– 1 –
4
3
1
5
2
E032019-CS-R01
150200001785A